---

Kirkham 427 Manual	Table of Contents

---

Roll Bar

Parts:
• grommets (2)
• 5/16-24 x 1.46” bolt (3)
• 5/16-24 x 1.72” bolt (5)
• 5/16-24 x 1.97” bolt
• 5/16-24 x 2.23” bolt
• 5/16” washer (16)
• 5/16” jet nut (10)
• 1/2” shcs (socket head cap screw) x 1 1/2” (2)

Tools:
• 1/2” wrench
• ratchet
• 3/8” socket
• 3/8” allen socket
• an assistant

Trunk mount with rear strut inserted

Rear bulkhead brace

Backside of rear bulkhead brace

1. Install the trunk mount using the 1.46” bolts on top and the 1.72” bolts on the bottom. (figure 1)
2. Slide the roll bar rear strut into the trunk mount.
3. Install the grommets in the holes on the cowl.
4. Lubricate grommets with windex or soapy water
5. Hold the rear bulkhead brace in place while installing the main part of the bar.
6. Slide the main part of the roll bar into place through grommets.
7. Use the other two 1.72” bolts to bolt on the back part of the rear bulkhead brace.
8. Check holes in strut to make certain all line up (and are not 180° off)
9. Bolt the strut in place using the 2.23” bolt in the trunk
10. Bolt the top of the strut with the 1.97” bolt.
11. Use the two 1/2” shcs's to bolt the main part of the roll bar to the frame.

---

Back one page
Req. from 38.107.191.102 on Thursday, 09-Sep-2010 20:09:08 GMT
Change date: Monday, 02-Jul-2007 20:59:11 MDT
Kirkham Motorsports - Ph: 801-377-8224 - sales@kirkhammotorsports.com
Copyright © Kirkham Motorsports